To Add, Reprogram Or Change A Keyless Entry Pin - Craftsman 139.53993DM Owner's Manual

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE "LEARN" BUTTON
1. Press and release the "learn" button on
motor unit. The learn indicator light will
glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit
personal identifi cation number (PIN) of your
choice on the keypad. Then press and hold
the ENTER button.
3. Release the button when the motor unit
lights blink. It has learned the code. If light
bulbs are not installed, two clicks will be
heard.
To change an existing, known PIN
If the existing PIN is known, it may be changed by one person without
using a ladder.
1. Press the four buttons for the present PIN, then press and hold the
# button.
The opener light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then press Enter.
The motor unit lights will blink once when the PIN has been learned.
Test by pressing the new PIN, then press Enter. The door should
move.
To set a temporary PIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours or
number of accesses, this temporary PIN expires and will no longer
open the door. It can be used to close the door even after it has
expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the last
temporary PIN), then press and hold the ✽ button.
The opener light will blink three times. Release the button.
One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been activated. This
feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds. The
keypad will blink twice when the one button close is active. The keypad will blink four times when one button close is deactivated.

To Add, Reprogram or Change a Keyless Entry PIN

USING THE PREMIUM CONTROL CONSOLE
NOTE: This method requires two people if the Keyless Entry is
already mounted outside the garage.
1. Enter a four digit personal identifi cation
number (PIN) of your choice on the keypad.
Then press and hold ENTER.
2. While holding the ENTER button, press and
hold the LIGHT button on the Premium
Control Console.
3. Continue holding the ENTER and LIGHT
buttons while you press the push bar on the
Premium Control Console (all three buttons
are held).
4. Release buttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
2. Press the temporary 4-digit PIN you have chosen, then press Enter.
The opener light will blink four times.
3. To set the number of hours this temporary PIN will work, press the
number of hours (up to 255), then press ✽.
3. To set the number of times this temporary PIN will work, press the
number of times (up to 255), then press #.
The opener light will blink once when the temporary PIN has been
learned.
Test by pressing the four buttons for the temporary PIN, then press
Enter. The door should move. If the temporary PIN was set to a
certain number of openings, remember that the test has used up one
opening. To clear the temporary password, repeat steps 1-3, setting
the number of hours or times to 0 in step 3.
36
OR