Install The Device Without A Mechanical Lift; Remove Components - IBM J36S Getting Started Manual

IBM Ethernet Appliance J36S Getting Started Guide

Install the Device Without a Mechanical Lift

To install the device without a mechanical lift:

Remove Components

To make the Ethernet appliance light enough to install manually, you first remove
most components from the chassis as shown in Figure 9 on page 10 and Figure 10
on page 11.
Figure 9: Components to Remove from the Front of the Device
10
Step 3: Install the Device
Remove Components on page 10
Lift the Chassis into the Rack on page 12
Reinstall Components on page 13
Power supplies
Switch Fabric Board (SFB)
Routing Engine
I/O Cards (IOCs)
Network Processing Cards (NPCs)
Services Processing Cards (SPCs)
Fan tray