IBM J36S Getting Started Manual page 11

Figure 10: Components to Remove from the Rear of the Device
NOTE: The procedure in this section for removing components from the chassis is
for initial installation only and assumes that you have not connected power cables
to the Ethernet appliance.
To remove the components from the device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see the IBM Ethernet Appliance J36S Hardware Guide.
Release each component by loosening its retaining screws and unlatching its
2.
ejector handles as appropriate. For full instructions on removing device
components, see the IBM Ethernet Appliance J36S Hardware Guide.
Slide each component out of the chassis evenly so that it does not become stuck
3.
or damaged.
Label each component as you remove it so you can reinstall it in the correct
4.
location.
Immediately store each removed component in an antistatic bag.
5.
Do not stack removed components. Lay each one on a flat surface.
6.
NOTE: For complete instructions on removing device components, see Installing
the Ethernet Appliance Without a Mechanical Lift" in the IBM Ethernet Appliance J36S
Hardware Guide.
Step 3: Install the Device
Step 3: Install the Device
11