Kobalt KMC 124B-03 Manual page 14

OPERATING INSTRUCTIONS
To Remove Wheel
a. Remove the battery pack.
b. Depress and hold the spindle-lock button (Q)
and remove the blade bolt (F) by turning it
clockwise with the wrench (R).
c. Remove the washer (G) and the outer flange
and remove the wheel.
7. Adjusting the Cutting Depth
WARNING
• Always maintain the correct cutting-depth
setting.
The correct cutting-depth setting for all cuts should
not exceed the thickness of the material being cut
by more than 1/4 in. (6.5 mm). Greater cutting depth
will increase the chance of dangerous kickback and
will cause the cut to be rough.
a. Remove the battery pack from the saw.
b. Raise the depth-lock lever (L) to release it.
c. Hold the tip of the base plate (A) tip against the
workpiece and raise or lower the saw until the
indicator mark (M) on the saw aligns with the desired depth on the depth scale (N).
d. Lower depth-lock lever to lock the selected cutting depth.
8. General Cutting
WARNING
• To make cutting easier and safer, always
maintain proper control of the saw. Loss of
control could cause an accident resulting in
serious injury. Never force the tool. Use a light
and continuous pressure.
DANGER
• Always make sure that the wheel has come to
a complete stop before setting the tool down.
A spinning blade contacting a hard surface will
cause the tool to walk back and may injure you.
6c
7
M
A
8a
14
wood flush cut wheel (V)
N
L