Sony XDCAM XDJ-1000 Installation Manual page 20

n
Attach the inner rails paying attention to the direction
of the stoppers shown in the fi gure.
Front side
Stopper
Inner rail
Rear side
Attaching the rack angles (handles)
5. Attach the two rack angles to both sides (left and right)
of the unit with the four screws.
Tightening torque:
138 x 10
N.m {14 kgf.cm}
-2
B4 x 10
Rack angle (L)
assembly
1-12 (E)
Stopper
Inner rail
B4 x 10
Rack angle (R)
assembly
Loosely attaching the rail brackets
6. Secure the mount rail attachment with the two nuts
(with washers) and two screws (B4 x 12) supplied
with the rail bracket.
Tightening torque:
138 x 10
_2
N.m {14 kgf.cm}
7. Temporarily secure the rail bracket (rear) to the mount
rail attachment with the two screws (PSW4 x 10)
supplied with the rail bracket.
PSW4 x 10
Nuts (with washers)
(supplied with rail bracket)
Mount rail
attachment
Outer rail
8. Temporarily secure the rail bracket (front) to the outer
rail with the two nuts (with washers) and two screws
supplied with the rail bracket.
Nuts (with washers)
(supplied with rail bracket)
Rail bracket (front)
Rail bracket (rear)
B4 x 12
(supplied with rail bracket)
Outer rail
B4 x 12
(supplied with rail bracket)
XDJ-1000