Installation Of Xdbk-J102 - Sony XDCAM XDJ-1000 Installation Manual

1-6. Installation of XDBK-J102

1. Remove the four screws, then pull out the drive mount-
ing plate.
Drive mounting plate
2. Remove the two harnesses from the two clamps, then
remove the drive mounting plate.
3. Remove the two screws, then remove the blank panel.
Blank panel
Clamps
Drive mounting plate
XDJ-1000
4. Fix the drive mounting plate to the drive assembly with
B3 x 5
5. Align the edge portions of the drive mounting plate
6. Connect the power cable and the SATA cable, then fi x
7. Push the drive mounting plate as far as it will go while
8. Fix it with the four screws.
PSW3 x 6
Harnesses
the four screws supplied with XDBK-J102.
PSW3 x 6
(supplied with XDBK-J102)
with the board supports and move it in the direction of
the arrow to the position where the power cable and
the SATA cable can be connected respectively.
them with the clamp.
being careful not to pinch the cables.
Board supports
Edge portion of
drive mounting plate
Drive assembly
Drive mounting plate
Power cable
SATA cable
Clamp
B3 x 5
1-5 (E)