Related Manuals for STIEBEL ELTRON WPIC-B
Summary of Contents for STIEBEL ELTRON WPIC-B
- Page 1 .CeC& eC .CZ`<<`.HC HTV`.HC C .CZ`<<`.HC e`.<.Z`.HC ` .CZ`<<`.HC ÷ ê ® ù Ï < Ï ’q| ¼ éq‚ ¼ ¼ ’ % › ê ® ù¼ Ï |ê ›¼ ä¼| ’ B ® ù¼ › |› ê |ùù| ê ê...
-
Page 2: Table Of Contents
HC`C`Z ’ HTV`.HC &CV< .C%HVB`.HC HC`C`Z HTV`.HC OPERATION ________________________________________________________ 10 General information General information _______________________________________ 10 The chapter “Operation” is intended for appliance users and hea- Further applicable documents _______________________________ 10 ting contractors. Other symbols in this documentation ______________________ 10 Units of measurement _________________________________________ 10 The chapter “Installation”... -
Page 3: Safety
HTV`.HC ’ .CZ`<<`.HC Z%`t .CZ`<<`.HC Safety Intended use The WPIC-B function module may only be operated in conjunction Safety with a WPL 13 E or WPL 13 basic which has been installed indoors and the function module HSBB. Only a qualified contractor should carry out installation, commis- Any other use beyond that described shall be deemed inappro- sioning, maintenance and repair of the appliance. -
Page 4: Fitting The Function Module
.CZ`<<`.HC TVTV.C& %HV .CZ`<<`.HC Fitting the function module Hydraulic connection Connect the function module to the heat pump using the supplied pressure hoses. f Place the function module on the heat pump and secure with two screws. Affix the type plate supplied to top front right-hand side of the side panel of the function module where it will be clearly visible. -
Page 5: Safety Valve
.CZ`<<`.HC ZT.%.`.HC Closing the function module 1 Gap between screw cap and connector body f Trim the pipe to the required length using only a pipe cutter. f Push the burr-free pipe past the O-ring into the connector as far as it will go. f Tighten the screw cap fully to the casing. -
Page 6: Connections And Dimensions
.CZ`<<`.HC ZT.%.`.HC Connections and dimensions “ qT. Entry electrical cables Safety assembly Heating flow Plug-in connection 28 mm Heating return Plug-in connection 28 mm Air intake Air discharge Ô ’ qT.é qqq Z`. <é<`VHC HB... -
Page 7: System Example
.CZ`<<`.HC ZT.%.`.HC System example Heat pump Function module WPIC-B Hydraulic module HSBB Outside temperature sensor Circulation pump Warranty Safety valve Expansion vessel The warranty conditions of our German companies do not Drain & fill valve apply to appliances acquired outside of Germany. In countries... - Page 8 CH`.xC ’ CH`Z ’ qT.é qqq Z`. <é<`VHC HB...
- Page 9 CH`.xC ’ CH`Z qqq Z`. <é<`VHC HB qT.é ’...
- Page 10 Deutschland Verkauf Tel. 0180 3 700705* | Fax 0180 3 702015* | info-center@stiebel-eltron.de STIEBEL ELTRON GmbH & Co. KG Kundendienst Tel. 0180 3 702020* | Fax 0180 3 702025* | kundendienst@stiebel-eltron.de Dr.-Stiebel-Straße | 37603 Holzminden Tel. 05531 702-90015 Tel. 05531 702-0 | Fax 05531 702-480 Ersatzteilverkauf Tel.
Need help?
Do you have a question about the WPIC-B and is the answer not in the manual?
Questions and answers