Adding The Gear Oil - KTM 250 EXC TPI Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.7
148
E00913-10
401955-11

Adding the gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
E00912-10
Main work
–
Remove gear oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
a new seal ring.
Guideline
Gear oil drain plug
with magnet
–
2
Remove filler plug with the O-ring, and fill up with gear oil.
Gear oil
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check for tightness.
Finishing work
–
Check the gear oil level. (
(All special models)
–
Install the engine guard. (
Preparatory work
–
Park the motorcycle on a level surface.
Main work
–
Detach the foot brake lever spring.
–
Remove gear oil level monitoring screw
1
with magnet.
1
with the magnet and
M12x1.5 20 Nm (14.8 lbf ft)
0.80 l Engine oil
(0.85 qt.) (15W/50)
( p. 166)
p. 147)
p. 97)
1
.