My Cooler Was Running Fine And Now It Won't Get Cold; My Room Is Getting Colder Than The Set Temperature; My Room Cools Down But The Temperature Will Raise Up Considerably Before It Cools Again (Temperature Swings) - Store It Cold CoolBot Instruction Manual And Troubleshooting Manual

●
Check the HEATER on the CoolBot (See MY HEATER DOES NOT SEEM TO
BE WORKING – Page 15).
●
Is your FINS Sensor positioned correctly? Make sure the CoolBot FINS Sensor
isn't touching a cooling pipe. If it is, you will get a false cold reading. Try pulling
it out completely and reinsert it so it is only ¼" in the fins.
●
After checking the above try lowering the Fins setting to 0 or even -1 (See
CHANGING SETTINGS ON THE COOLBOT- Fins Setting – Page 11). If you
try a negative Fins Setting, be sure to check frequently for frost. If frost occurs,
raise the fins back to a positive number setting.

MY COOLER WAS RUNNING FINE AND NOW IT WON'T GET COLD

●
Is the compressor running? Unplug the A/C unit and reset it following the
instructions in the owner's manual of your A/C unit.
●
Are the fins clean? See DIRTY FINS (Page 15).
● Is your A/C in the "COOL" mode and the fan on "HIGH"?
●
Did you check your HEATER foil connection? See INSTALLING YOUR
COOLBOT-STEP 5 (Page 7).
● Did something change from the original setup? Please see MY ROOM WON'T
GET COLD ENOUGH (Page 16).

MY ROOM IS GETTING COLDER THAN THE SET TEMPERATURE

●
Is your cooler empty? Adding mass to any cooling space helps hold
temperatures stable and reduces fluctuations.
NOTE: Florists - adding 5 gal buckets of water helps.
●
Is the HEATER foil connection over insulated? Make sure you use ONLY a
2x2 inch piece of aluminum foil as described in STEP 5 of INSTALLING
YOUR COOLBOT (Page 7). DO NOT use duct tape, insulating pipe tape or
other materials.
●
Is your A/C oversized? This can happen in small rooms with big A/Cs.
Turn A/C to "ENERGY SAVER" mode OR turn A/C fan to "LOW" and Heater
Delay to "d3+."
MY ROOM COOLS DOWN BUT THE TEMPERATURE WILL RAISE UP
CONSIDERABLY BEFORE IT COOLS AGAIN (TEMPERATURE SWINGS)
●
Do you have a Secondary Sensor? Please see STEP 6 of INSTALLING YOUR
COOLBOT (Page 8).
●
Is your cooler empty? Adding mass to any cooling space helps hold
temperatures stable and reduces fluctuations.
NOTE: Florists - adding 5 gallon buckets of water helps.
●
Is the HEATER foil connection in the air draft? Make sure they are away from
the fins and the airflow, not touching anything cold or metal. See STEP 5 -
INSTALLING YOUR COOLBOT (Page 7).
Rev: 2017 – 11A
©2017 Store It Cold, LLC 17