Troubleshooting Guide; Er" Showing On My Coolbot Display - Store It Cold CoolBot Instruction Manual And Troubleshooting Manual

If you are experiencing problems with your cooler please double-check all the
requirements in the BEFORE INSTALLING YOUR COOLBOT (Page 6) section of this
manual and make sure that you have followed all the steps in the INSTALLING YOUR
COOLBOT (Page 7) section of this guide.

"Er" SHOWING ON MY COOLBOT DISPLAY

"Er" is a communication error with the ROOM sensor.
●
Unplug the ROOM sensor from the CoolBot.
●
Inspect the cable for possible damages in the cord or on the tip.
●
Clean the plug end of the sensor (jack connector) with a cotton cloth and plug
it back in the CoolBot port a couple times making sure it goes all the way in.
●
If the error persists after 20 seconds, unplug the sensor from the Room port
and switch ports with the FINS sensor by plugging the ROOM sensor in the
Fins port and the FINS sensor in the Room port.
● If the "Er" message is gone and now you have a flashing "Ef" while the Fins
Mode light blinks rapidly, then your ROOM sensor cable (currently plugged in
the Fins port) is bad and needs replacement.
●
Plug the FINS sensor back into the Fins port.
●
Discard your ROOM Sensor.
● "Er" will still show on the display (because there is nothing plugged in the Room
port). That is all right.
NOTE: CoolBot runs perfectly fine with 1 good sensor (plugged in the Fins port) in a
"Safety Mode" while your replacement sensor is being shipped.
Since the CoolBot won't display the room temperature while running in the "Safety
Mode," the Room temperature will have to be monitored with the aid of an external
thermometer.
To order a new sensor please visit our parts page at:
https://www.storeitcold.com/replacement-parts/
To order a replacement sensor under warranty (1 year) please contact our support team
at support@storeitcold.com.
Rev: 2017 – 11A

TROUBLESHOOTING GUIDE

©2017 Store It Cold, LLC 13