Identifying Parts; Needles - JUKI Union Special 36200L220-60 Adjusting Instructions And Illustrated Parts List

Table of Contents

This manual has been arranged to simplify ordering repair parts. Exploded views of various sections of the mechanism are shown

so that the parts may be seen in their actual position in the machine. On the page opposite the illustration will be found a listing

of the parts with their part numbers, description and the number of pieces required in the particular view being shown.

Numbers in the first column are reference numbers only, and merely indicate the position of the part in the illustration. The

reference number should never be used in ordering parts. Always use the part number listed in the second column.

Component parts of sub-assemblies which can be furnished for repairs are indicated by indenting their descriptions under the

description of the main sub-assembly. As an example refer to the following text.

29126 EC

Upper Looper Drive Shaft Assembly ................................................................................. 1

10.

22503 F

Screw ....................................................................................................................................... 1

11.

39543 E

Cam Follower Locking Clamp ..................................................................................... 1

It will be noted in the previous example that the cam follower, bushing and cam guide and the upper looper drive shaft are not

listed. The reason is that replacement of these parts individually is not recommended, so the complete upper looper drive shaft

assembly should be ordered.

When a part is common to all machines covered in this manual, no specific usage will be mentioned in the description. However,

when the parts for the various machines are not the same, the specific usage will be mentioned in the description and, if necessary,

the difference will be shown in the illustration.

A numerical index of all the parts shown in this manual is located at the back. This will facilitate locating the illustration and

description when only a part number is known.

Where the construction permits, each part is stamped with its part number. On some of the smaller parts and on those where

construction does not permit, an identification letter is stamped in to distinguish the part from similar ones.

PLEASE NOTE:

Part numbers represent the same part, regardless of which manual they appear. On all orders please include

part number, name and style of machine for which the part was ordered.

Each needle has both a type and size number. The type number denotes the kind of shank, point, length, groove, finish and other

details. The size number, stamped on the needle shank, denotes the largest diameter of the blade measured between the shank

and the eye. Collectively, the type number and size number represent the complete symbol which is given on the label of all

needles packed and sold by Union Special.

TYPE

116GKS

Round shank, round point, extra short, double groove, struck groove, spotted, chromium plated needle.

.048 (1.2mm) Diameter Shank. Size 065/025 available only.

When changing the needle, make sure it is fully inserted in the needle driving arm before the clamp screw is tightened.

To have needles promptly and accurately filled, an empty package, a needle sample, or the type and size number should be

forwarded. Use the description on the label. A complete order should read as follows: "100 needles, type 116 GKS, size 065/025".

ILLUSTRATIONS