Style Of Machines (Cont.); Illustrations; Identifying Parts; Terms - JUKI UnionSpecial 35800BLWG Adjusting Instructions / Illustrated Parts List

Table of Contents

This manual has been arranged to simplify ordering repair parts. Exploded views of various sections of the

mechanism are shown so that the parts may be seen in their actual position in the machine. On the page

opposite the illustration will be found a listing of the parts with their part numbers, description and the

number of pieces required in the particular view being shown.

Numbers in the first column are reference numbers only, and merely indicate the position of the part in the illustration. The

reference number should never be used in ordering parts. Always use the part number listed in the second column.

Component parts of sub-assemblies which can be furnished for repairs are indicated by indenting their descriptions under

the description of the main sub-assembly. As an example refer to the following text.

9. 29126 EC

Upper Looper Drive Shaft Assembly ................................................................................ 1

10. 22503 F

Screw ............................................................................................................................. 1

11. 39543 E

Cam Follower Locking Clamp ......................................................................................... 1

It will be noted in the previous example that the cam follower, bushing and cam guide and the upper looper drive shaft

are not listed. The reason is that replacement of these parts individually is not recommended, so the complete upper looper

drive shaft assembly should be ordered.

When a part is common to all machines covered in this manual, no specific usage will be mentioned in the description.

However, when the parts for the various machines are not the same, the specific usage will be mentioned in the description

and, if necessary, the difference will be shown in the illustration.

A numerical index of all the parts shown in this manual is located at the back. This will facilitate locating the illustration and

description when only a part number is known.

Where the construction permits, each part is marked with its part number. On some of the smaller parts and on those where

construction does not permit, an identification letter is marked in to distinguish the part from similar ones.

PLEASE NOTE:

Part numbers represent the same part, regardless of which manual they appear. On all orders please

include part number, name and style of machine for which the part was ordered.

Prices are net cash and subject to change without notice. All shipments are forwarded F.O.B. shipping point.

A charge is made to cover postage and insurance.

Table of Contents