Electrolux EHF3320FOK User Manual page 25

Problem
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
The Automatic Heat Up
function does not oper-
ate.
You cannot activate the
outer ring.
The sensor fields be-
come hot.
comes on.
comes on.
and a number come
on.
If you tried the above solutions and can-
not repair the problem, speak to your
Possible cause
The STOP+GO function
operates.
There is water or fat
stains on the control pan-
el.
You put something on
one or more sensor
fields.
You put something on
the sensor field
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting
is set.
You decreased the heat
setting from .
The cookware is too
large or you put it too
near to the controls.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
There is an error in the
appliance.
dealer or the customer service. Give the
data from the rating plate, three digit letter
Remedy
Refer to the chapter "Daily
Use".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
.
If the cooking zone oper-
ated sufficiently long to be
hot, speak to the service
centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Start from
crease the heat setting.
Activate the inner ring first.
Put large cookware on the
rear cooking zones if nec-
essary.
Deactivate the appliance
and activate it again.
Refer to the chapter "Daily
Use".
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If
on again, speak to the
service centre.
ENGLISH 25
and only in-
comes