Poe Max Led In The Device View; Configure Interface Settings - NETGEAR GS108Tv3 User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)

PoE Max LED in the Device View

For models GS110TPv3 and GS110TPP, the PoE Max LED indicates the following status:
• Off. Sufficient (more than 7W of) PoE power is available.
• Solid yellow. Less than 7W of PoE power is available.
Note: The physical PoE Max LEDs on the switch can also blink yellow,
indicating that at least once during the previous two minutes, less than
7W of PoE power was available.

Configure interface settings

The switch supports physical and logical interfaces. Interfaces are identified by their type and
the interface number. The physical ports are Gigabit interfaces and are numbered on the
front panel. You configure the logical interfaces by using the software.
The following table describes the naming convention for all interfaces available on the switch.
Table 7. Naming conventions for interfaces
Interface
Physical
Link aggregation group (LAG)
CPU management interface
For some features that allow you to configure interface settings, you can apply the same
settings simultaneously to any of the following:
• A single port
• Multiple ports
• All ports
• A single LAG
• Multiple LAGs
• All LAGs
• Multiple ports and LAGs
• All ports and LAGs
Get Started
Cloud Management
Description
The physical ports are Gigabit Ethernet interfaces and are
numbered sequentially starting from 1.
LAG interfaces are logical interfaces that are used only for
bridging functions.
This is the internal switch interface responsible for the switch
base MAC address. The interface is not configurable and is
always listed in the MAC Address Table.
44
Example
g1, g2, g12
l1, l2, l3
c1
User Manual