Configure Link Aggregation Groups; Configure Lag Settings - NETGEAR GS108Tv3 User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
The following table describes the nonconfigurable data that is displayed.
Table 27. Port Configuration information
Field
Port Type
Physical Status
Link Status
Frame Size (1522 to 10000)
MAC Address
PortList Bit Offset
ifIndex

Configure link aggregation groups

Link aggregation groups (LAGs), which are also known as port channels, allow you to
combine multiple full-duplex Ethernet links into a single logical link. Network devices treat the
aggregation as if it were a single link, which increases fault tolerance and provides load
sharing. You assign the LAG VLAN membership after you create a LAG. By default, the LAG
becomes a member of the default management VLAN (that is, VLAN 1).
A LAG interface can be either static or dynamic, but not both. All members of a LAG must
participate in the same protocols. A static port channel interface does not require a partner
system to be able to aggregate its member ports.
The switch supports static LAGs. When a port is added to a LAG as a static member, the port
neither transmits nor receives LACPDUs.
The switch supports eight LAGs.

Configure LAG settings

You can group one or more full-duplex Ethernet links to be aggregated together to form a link
aggregation group, which is also known as a port channel. The switch treats the LAG as if it
were a single link.
Configure Switching
Cloud Management
Description
For normal ports this field is blank. Otherwise, the options are as follows:
• Mirrored. The port is a mirrored port on which all the traffic is copied to
the probe port.
• Probe. Use the port to monitor a mirrored port.
• Trunk Member. The port is a member of a link aggregation trunk. Look
at the LAG pages for more information.
The port speed and duplex mode.
Indicates whether the link is up or down.
The maximum Ethernet frame size that each interface can support. The
frame size depends on your selection from the Frame Size menu above the
table and applies to each interface.
The physical address of the specified interface.
The bit offset value that corresponds to the port when the MIB object type
PortList is used to manage in SNMP.
The ifIndex of the interface table entry associated with the port.
143 User Manual