Oi26 - Curtis Alpha FreshTrac G3 Series User Manual

OPERATING INSTRUCTIONS
Using the FreshTrac
Selected models of the Alpha series brewer are equipped with the FreshTrac freshness timer system. The
FreshTrac receiver clips to the side of the handle of an Alpha series glass decanter. When used with Alpha series
For proper operation, the FreshTrac decanter must be placed in the proper orientation before brewing. See
FreshTrac Decanter Placement below.
• The timer is set at the brewer's universal
control module (UCM). The factory setting is
30 minutes. The adjustment range is from ten
minutes to two hours. See the Programming
Guide section to change the FreshTrac-Glass
settings.
• At the beginning of the brew cycle, the brewer
transmits a signal to the decanter receiver,
been reset. When the freshness time set on
to inform the user that the coffee is no longer
one hour.
• The FreshTrac decanter and receiver are dishwasher safe.
• The expected receiver battery life is two years. The integral receiver battery is not replaceable,
however the receiver itself can be removed from the decanter and replaced. Order Curtis part number
WC-10003.
FreshTrac Decanter Placement
The most effective timer signal reception
for the FreshTrac receiver is within the
230º range shown in the FreshTrac Handle
Location Diagram. Place the FreshTrac
decanter on the warmer with the handle
as shown for best performance.
ALPHA FRESHTRAC, OPERATING INSTRUCTIONS
Timer
®
Warmer
FreshTrac Transmitter
Brewer
Transmitter
FreshTrac
receiver
FreshTrac Handle Location Diagram - Top View

OI26

When BREW is
pressed, UCM
transmits signal to
reset and start timer
inside FreshTrac
receiver on
decanter.
FreshTrac Reciever
Transmitter
signal
230° - Limits of
handle rotation
Decanter handle
100317NC