Curtis Alpha FreshTrac G3 Series User Manual page 16

PROGRAMMING GUIDE
Programming Options
Some menus save and exit automatically when a parameter is updated. Other menus exit to the previous menu
when a parameter is saved. To exit, press
Brew by Volume -
button again to stop the brew cycle and set the volume.
Brew by Time - adjusts the amount of coffee brewed by time rather than by volume (the factory default is
change the number value. Press
change the number value. Press
Temperature -
to set and exit.
Energy Save Mode - saves energy during periods when the brewer is not in use (the factory default is
temperature faster after periods of non-use. Once accessed, press
Then press to set and exit.
Brew Count Odom - When accessed, this feature displays the total brew cycles since the odometer was last
reset. Press to exit or
Pre-Infusion -
seconds. Once accessed, press
Quality Timer -
"Quality Timer"
Brew Count Total - when accessed, displays the total brew cycles on the brewer. It cannot be reset. The
display returns to the previous screen automatically after a few seconds.
Cold Brew Lock -
pressed (Ready to Brew
choose the desired setting. Then press
Master Reset -
accessed, "Are You Sure?" will appear on the display. Press
until EXIT appears on the display, then press
or
or
or
reset and exit.
or to choose the desired setting, then, press
to set and exit.
to exit.
or to choose the desired temperature. Then press
or to choose the desired setting.
or to increase or decrease the amount
to set and exit.
for Yes or for No.
PG9
.
to
repeatedly
to
repeatedly
to exit. To turn off pulse
or to