Advertisement
INSTALLATION INSTRUCTIONS
Apply thread sealant.
Insert the stopper into the fl ange.
For regular installations, insert the short end of the rod into the body seal hole and under the stopper.
For vandal-resistant installations, fi t the rod through the hole in the stopper.
Handtighten the body nut.
Remove and adjust the stopper as needed so it lifts about 3/8" (10 mm) when opened. To adjust, rotate the
threaded stopper rod in or out as needed. Retighten the stopper nut.
Apply thread sealant tape to the tailpiece threads, and thread the tailpiece to the body. Tighten the tailpiece
securely. Slide one end of the clip onto the rod. Slide the link onto the rod with the thumbscrew facing the
back of the fi xture.
Supply Hoses
(Not Provided)
Install the lavatory according to the lavatory manufacturer's instructions.
Connect the supply hoses (not provided) to the supply stops. (Left is hot; right is cold.)
Tighten all connections with an adjustable wrench.
1133090-2-E
5 of 6
4. COMPLETE THE DRAIN INSTALLATION
Stopper
Body
Tailpiece
5. COMPLETE THE CONNECTIONS
Cold
Hot
Stopper Rod
Flange
Nut
Rod
Nut
Clip
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Basin Set
Thumbscrew
Link
Advertisement
