The appearance of your product may differ from what is shown in these instructions, however, the installation procedure is the same. KALLISTA reserves the right to make revisions in the design of products without notice, as specifi ed in the Price Book.
Page 3
Hold the spout in position and tighten the tee securely. Do not overtighten. For P22731 only: Install the rubber washers, gaskets, and check valves onto the tee assembly. If desired, apply a bead of silicone sealant or caulk around the base of the spout.
Make sure the drain body seal hole is facing the back of the fi xture, and securely tighten the nut. Remove any excess putty or sealant. 1133090-2-E Questions? Problems? For additional assistance, please contact KALLISTA’s Customer 4 of 6 Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Page 5
Connect the supply hoses (not provided) to the supply stops. (Left is hot; right is cold.) Tighten all connections with an adjustable wrench. 1133090-2-E Questions? Problems? For additional assistance, please contact KALLISTA’s Customer 5 of 6 Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Run water through the spout for 1 minute to remove any debris. Turn off the valves. Reinstall the aerator. Retain the key for future use. 1133090-2-E Questions? Problems? For additional assistance, please contact KALLISTA’s Customer 6 of 6 Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.