INSTALLATION INSTRUCTIONS
Thread the male ends of the hoses into the valves. Do not overtighten.
Thread the female ends of the hoses onto the tee.
Remove the protective cover from the fl ange.
Apply a ring of plumbers putty or other sealant to the underside of the fl ange according to the
manufacturer's instructions.
Assemble the nut, fl at washer, and tapered gasket (tapered side up) fully onto the drain body.
From the underside of the fi xture, insert the drain body up into the drain hole.
From the top of the fi xture, securely handtighten the fl ange onto the drain body.
Make sure the drain body seal hole is facing the back of the fi xture, and securely tighten the nut.
Remove any excess putty or sealant.
1133090-2-E
4 of 6
2. CONNECT THE HOSES
Valve
Hose
3. INSTALL THE DRAIN
Gasket
Washer
Nut
Valve
Hose
Flange
Apply plumbers putty.
Drain Body
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Basin Set