Fig.10. IP Configuration: WebCAM Advanced settings
i.
Device Password
Use this to set an access password to the individual device.
user must enter the password to access the device.
Address will not be shown on the right display panel of Utility.
Utility will request for the "Input Device Password" when you click either "Setup
Wizard", "Launch WebCAM" or "IP Configuration"
WebCAM user manual
Chapter 4: Using Utility to Setup IP & Update Firmware
Once set, the
In addition, the IP
Devise
Password
not set.
Devise
Password
enabled. IP
Address
hidden.
-18-