Customized Settings - Acura 2010 TSX Owner's Manual

Customized Settings

DRIVER'S ID
You can customize some vehicle
control settings. To enter the
customizing mode, press and hold
either INFO button ( / ) for more
▲ ▼
than 3 seconds. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park (automatic) or
with the parking brake set (manual).
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, move the shift lever out of
Park (automatic) or release the
parking brake (manual), the display
will change to the normal screen.
If you try to enter the customizing
mode while the vehicle is moving,
you will see a ''MUST STOP AND
SHIFT TO PARK TO CHANGE
SETTINGS'' (automatic) or ''MUST
STOP AND SET PARK BRAKE TO
CHANGE SETTINGS'' (manual)
message and you cannot change the
settings.
You can customize some vehicle
control settings for ''DRIVER 1'' and
''DRIVER 2'' separately. If ''DRIVER
1'' or ''DRIVER 2'' is not displayed,
customizing is not possible.
To have the driver's ID detected,
make sure your remote transmitter
is linked to the system and the
driver's door is unlocked with a
2010 TSX
Multi-Information Display
corresponding remote transmitter.
See page 128 to link your remote
transmitter to your vehicle.
If the remote transmitter is not
linked, ''DRIVER UNKNOWN
CUSTOMIZE IMPOSSIBLE'' will be
displayed, and you cannot customize
the settings.
If you use the key to unlock the
driver's door, the system cannot
recognize either ''DRIVER 1'' or
''DRIVER 2.''
If you want to change any vehicle
control settings, select CHG
SETTING, then press the SEL/
RESET button.
Refer to the table on the following
pages about the settings you want to
customize.
CONTINUED
81