Commissioning and adjustment
Setting the mixer extension kit parameters
04. Use
/
to select "SERVICE".
05. OK to confirm
06. Use
/
to select "TSP-PARAM-
ETER".
07. OK to confirm
08. Use
/
to select the required
parameter.
For information on the
parameters, see the instal-
lation and service instruc-
tions for the heating circuit
extension kit.
Further settings
1. Press MODE.
2. Use
/
to select "SETTINGS".
3. OK to confirm
4. Use
/
to select "SERVICE".
Temperature balancing (wall compensation)
If the controller is mounted in an unfav-
ourable installation location, the room
temperature displayed may deviate
from the actual room temperature. The
temperature deviation can be adjusted
with a correction value.
1. Use
/
to select "WALL
COMP".
16
(cont.)
09. OK to confirm
10. Set the required value with +/-.
11. OK to confirm
5. OK to confirm
6. Use
/
to select the required set-
ting.
See following chapter.
7. OK to confirm
2. OK to confirm
3. Use +/- or the rotary selector to set
the required corrected temperature.
4. OK to confirm