Table of Contents
Advertisement
IMPORTANT PRECAUTIONS
1
Unplug the Quantum X when
not in use. Turn it off at the
main switch before unplugging.
Grasp the plug to disconnect
it from the back of the main
unit or from the wall outlet
to avoid damage to cord,
plug, prongs or receptacle.
DO NOT pull or carry by cord,
use cord as a handle, close
a door on cord, pull or carry
around sharp edges or corners.
DO NOT run appliance over
cord, Keep cord away from
heated surfaces. Do not use
with damaged cord or plug.
When used as a vacuum
2
cleaner, DO NOT leave
appliance when plugged in.
Unplug main unit from the
back of the machine or wall
outlet when unattended
and before servicing or
replacing the motorized
power head drive belt.
3
DO NOT use the main electrical
power head to pick up liquids.
The Quantum X is intended for
small wet spills. Do not use on
wet surfaces such as: standing
water, excess water, large
6
2018-10-22 v18 color QX.indd 6
spills, or liquid volumes larger
than one and a half quarts.
4
If your Quantum X unit or
accessory is in disrepair,
DO NOT attempt to operate.
If the main unit is not working
properly, has been dropped,
damaged, left outdoors or
dropped in water, contact
an Authorized Quantum X
Service Center for inspection.
5
DO NOT clean the unit or
unplug the hose until the
Quantum X is switched off
and the plug is removed
from the back of the
Quantum X or wall outlet.
6
DO NOT connect to the
receptacle of an incandescent
light fixture or use any
extension cords other than
what's approved by Quantum
X Company. DO NOT use
with portable transformers
or voltage converters.
7
DO NOT allow to be used as
a toy. This appliance can be
used by children aged 8 years
and above and persons with
22.10.2018 19:40:01
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Quantum X and is the answer not in the manual?
Questions and answers
How do I keep the top part stable with the bottom. It rolls all over making it very heavy.
Make sure the Quantum X is in the upright position. Press the foot release button to lock the handle in place, preventing it from rolling.
This answer is automatically generated
@Mr. Anderson my rolls all over when vacuuming tried lock did not work.
Why is the head light on the vacuum "flashing on/off" ??
Flashing headlights on the Quantum X vacuum may indicate an electrical issue or a blockage. Troubleshooting suggests checking for blockages, but if the vacuum is new and was only used once, it could be a faulty unit. If the problem persists, seeking professional help is recommended.
This answer is automatically generated
@Mr. Anderson , I check for blockages and didn't find any. But, the roller brush is no longer turning. It is not very clogged with long hairs. I cleaned the roller brush and it turns freely. It will not turn when the vacuum is on. Thank you for the help, Paul
I can not get the hose out of the vacuum
To remove the hose from the Quantum X vacuum, locate the back of the machine where the hose connects. Identify the notch on the hose connector—it must be aligned straight up and down to fit into the slot. To remove the hose, twist it to unlock, then pull it out.
This answer is automatically generated
I received the filter replacement but can’t get the cap off to take broken part off and replace with new screw cap
I'm trying to unscrew the bottom plate to take the brush out to clean. I think I screwed it up!!
To remove the bottom plate of the Quantum X to clean the brush, you need to take out all the screws on the bottom. Once the screws are removed, the bottom plate will come off, giving you access to the brush area for cleaning.
This answer is automatically generated
Tried to take off cap to insert vacuum hose but it wouldn’t budge, Actuallly, the two tabs to take it off both broke of. What do I do now. Do you have a replacement part for that part.
how do you clean the rotating bar of hair etc.? Can you take it out to clean it?
To clean the rotating bar (brush) on the QUANTUM X, do not remove the bottom panel, as doing so does not help with cleaning, can damage the vacuum, and voids the warranty. Instead, use small scissors and a comb to remove hair from the brush while it is still in place. The brush cannot be removed for cleaning.
This answer is automatically generated
My vacuum smells moldy when I turn it on. It made the whole room smell.
The QUANTUM X vacuum smells moldy when turned on because dust and debris clog the filters, which then blow out and recirculate into the air. After use, storing the warm vacuum in a dark closet creates a breeding ground for bacteria and viruses. These germs multiply, causing a stale, musty odor when the vacuum is used again.
This answer is automatically generated
I cant pull the hose out of the back
Hose is stuck