Table of Contents
Advertisement
Placing the handset in the base station
and registering
¤
Place the handset in the base station
with its display facing upwards.
The handset registers automatically.
Registration can take up to 5 minutes.
While this is happening,
appears in the display and the name of the
base station flashes. The handset is
assigned the lowest available internal
number (1–4).
This will appear in the display when regis-
tration is complete, e.g.
that the number 1 has been assigned.
If the internal numbers 1–4 are already
assigned to other devices, the number 4 is
overwritten.
Please note:
– Automatic registration is only possible
while no calls are being made from the
base station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 20).
– You can change the name of the handset
(page 22).
To charge the batteries, leave the handset
in the base station.
Please note:
– The handset will automatically switch on if
it is placed in the base station.
– Only place the handset in the base station
or charging cradle that is intended for it.
For questions and problems see page 30.
Regstr.Procedure
INT
1. This means
Headset socket
You can connect various headset types
(with 2.5 mm jack connector).
A compatibility list of tested headsets can
be found on the Internet at
www.plantronics.com/productfinder.
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon e in the top right of the dis-
play indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries (page 1). The correct charge level
can only be displayed if the batteries are
first fully charged and discharged.
¤
To do this, leave the handset in the
base station or charging cradle with-
out interruption for five hours.
¤
Afterwards, remove the handset from
the base station and do not put it back
again until the batteries are fully dis-
charged.
Please note:
After the first battery charge and discharge
you may replace your handset in its base sta-
tion after every call.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and reinsert
them.
u
The batteries may warm up during
charging. This is not dangerous.
u
After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
First steps
7
Advertisement
Table of Contents
