Table of Contents
Advertisement
S
S
UPER
ERVER 6014H-8/6014H-82/6014H-X8 Manual
CD-ROM and Floppy Drive Installation
The top cover of the chassis must be opened to gain full access to the CD-
ROM and floppy drive bays. The 6014H-8/6014H-82/6014H-X8 accomodates
only slim CD-ROM and floppy drives. Side mounting brackets are needed to
mount a slim CD-ROM drive in the 6014H-8/6014H-82/6014H-X8 server.
You must power down the system before installing or removing a floppy or
CD-ROM drive.
unit to the rack.
straight out until it locks (you will hear a "click").
buttons on the top of the chassis to release the top cover and at the same
time, push the cover away from you until it stops. You can then lift the top
cover from the chassis to gain full access to the inside of the server.
With the chassis cover removed, unplug the power and data cables from
the drive you want to remove. Then locate the locking tab at the rear of the
drive. It will be on the left side of the drive when viewed from the front of
the chassis. Pull the tab away from the drive and push the drive unit out
the front of the chassis.
reverse order.
drive is fully inserted. Remember to reconnect the data and power cables
to the drive before replacing the chassis cover and restoring power to the
system.
Please be aware of the following:
• The floppy disk drive cable has seven twisted wires.
• A color mark on a cable typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors
to provide for two floppy disk drives.
always connects to drive A, and the connector that does not have
twisted wires always connects to drive B.
First, release the retention screws that secure the server
Grasp the two handles on either side and pull the unit
Add a new drive by following this procedure in
You may hear a faint *click* of the locking tab when the
The connector with twisted wires
6-8
Next, depress the two
Advertisement
Table of Contents
