Adding Pci Cards - Supero SUPERSERVER 6015B-Ni User Manual

5-6

Adding PCI Cards

1. PCI Expansion Slots
Two riser cards are used to support add-on cards to the system. The SC812L-520U
chassis can accommodate two standard size (full height full length) and one low
profi le PCI expansion card. When viewed from the chassis front, the standard size
card installs to the left and the low-profi le card installs to the right side.
PCI cards are installed into riser cards that have been pre-installed to the system.
An additional two riser cards are included to support PCI-E add-on cards. See
confi guration list below.
2. PCI card installation
Before installing a PCI add-on card, make sure you install it into the correct riser
card. Begin by releasing the locking tab that corresponds to the slot you wish to
populate. Insert the expansion card into the correct riser card, pushing down with
your thumbs evenly on both sides of the card.
PCI Slot/Card Confi gurations
Right Side Riser Cards
RSC-R1UU-XR
RSC-R1UU-E8R (in accessory box)
Left Side Riser Card
CSE-R1UU-2E8
Chapter 5: Advanced Serverboard Setup
Expansion card supported
1x PCI-X 133 MHz card
1x PCI-Express x8 card
Expansion card supported
2x PCI-E x8 cards
5-9