Bartscher I3WL820 2/1 GN Manual page 14

Positioning

Put the device on an even, stable, dry and waterproof surface which is resistant to
high temperature.

Never place the device on an inflammable surface.

Do not place the device near open flame, electric heaters or other heat source.

Never place the device at the edge of a table to avoid tilting or falling.

Never put the device in a moist or wet area.

Never locate the device in the direct vicinity of walls, low wall, kitchen furniture, or
other objects. Make sure there is enough distance (at least 30 cm) from walls and
other flammable or prone to discolouration objects. Follow the valid fire protection
regulations.

When it is not possible to leave the recommended distance, use appropriate
protection means (e.g. heat-resistant foil that will ensure keeping the wall
temperature within the safe range.

Always keep the working area around the device clean and dry.

When locating the device, make sure the power plug is easily accessible to
immediately unplug the device, if necessary.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!

The power supply circuit with the socket must be protected by the fuse of at least 16A.
Connect the device directly to a single grounded socket. Do not use any power bar or
multiple socket.
- 29 -