GE 22 Owner's Manual & Installation Manual page 41

Troubleshooting Tips...Before you call for service
Problem
Cube dispenser does not
work (on some models)
Water has poor taste/odor (on
some models)
Water in first glass is warm
(on some models)
Water dispenser does not
work (on some models)
Water spurting from
Water is not dispensed (on
some models) but icemaker
is working
No water or ice cube
production
CUBED ice was selected but
CRUSHED ice was dispensed
(on some models)
Refrigerator has odor
Moisture forms on outside of
refrigerator
Moisture collects inside (in
humid weather, air carries
moisture into refrigerator
when doors are opened)
Interior light does not work
49-60647-5
Possible Causes
Icemaker or water supply turned off.
Ice cubes are fro en to icemaker feeler
arm.
An item is blocking or has fallen into
the ice chute inside the top bin of the
free er.
Irregular ice clumps in storage
container.
Dispenser is LOCKED.
Water dispenser has not been used for
a long time.
Normal when refrigerator is first
installed
Water dispenser has not been used for
a long time.
Water system has been drained.
Water supply line turned off or not
connected.
Water filter clogged.
Air may be trapped in the water system. Press the dispenser arm for at least two minutes.
Dispenser is LOCKED.
Newly-installed filter cartridge.
Water in reservoir is fro en.
Refrigerator control setting is too cold.
Supply line or shutoff valve is clogged.
Water filter clogged.
Dispenser is LOCKED.
Last setting was CRUSHED ice.
Foods transmitting odor to
refrigerator.
Interior needs cleaning.
Not unusual during periods of high
humidity.
Too frequent or too long door
openings.
Due to the higher himidity in the
refrigerator, you may on occasion
experience fog or small amounts
of moisture in the refrigerator
compartment
No power at outlet.
Light bulb burned out.
For LED lights
What To Do
Turn on icemaker or water supply.
Remove cubes.
Remove any item that might be blocking, or has fallen
into the chute.
Break up with fingertip pressure and discard remaining
clumps.
a colder setting, one position at a time, until clumps do
not form.
Press and hold the Lock or Lock Controls pad for 3
seconds.
Wait 24 hours for the refrigerator to completely cool
down.
Allow several hours for replenished supply to chill.
Replace filter cartridge or remove filter and install plug.
Press and hold the Lock or Lock Controls pad for 3
seconds.
Run water from the dispenser for 3 minutes (about 1
gallons).
Call for service.
Set to a warmer setting.
Call a plumber.
Replace filter cartridge or remove filter and install plug.
Press and hold the Lock pad for 3 seconds.
A few cubes were left in the crusher from the previous
setting. This is normal.
replace every three months.
See Care and cleaning.
Wipe surface dry.
This is normal for the beverage center.
This is normal and may come and go as different food
loads and environmental conditions change. Wipe dry
with a paper towel if desired.
Replace fuse or reset the breaker.
See Replacing the light bulbs.
Call Service.
/
1
2
41