Table of Contents
Advertisement
NI PXIe-5185/5186 Startup Behavior
The first time you install the NI 5185/5186 in the chassis, the NI-SCOPE driver launches a
device recognition wizard. After the wizard completes, the NI 5185/5186 module goes through
an initialization procedure that lasts approximately 5 to 10 minutes. You must wait until the
initialization procedure completes before using the module.
The Access LED turns green when the module is ready to be configured.
Note
The initialization procedure will occur on each subsequent use of the NI 5185/5186, although
the device recognition wizard is not repeated on each subsequent boot cycle. The module will
begin the initialization procedure after the NI-SCOPE driver has been loaded by the operating
system.
PCI Devices
To install a PCI device, complete the following steps:
1.
Power off and unplug the PC.
2.
Remove the PC cover.
3.
Insert the device into an open PCI slot as shown in Figure 5.
1
NI PCI Device
To maximize airflow and extend the life of the PCI device, leave any adjacent
Tip
PCI slots empty.
4.
Secure the device to the PCI chassis with a screw.
Caution
both for mechanical stability and to create a solid ground connection. Improperly
secured devices may affect the accuracy of the device.
8 | ni.com | NI High-Speed Digitizers Getting Started Guide
Figure 5. PCI Installation
1
2
2
PCI Slot
It is important to completely screw the device front panel into the PCI slot,
3
3
PC
Advertisement
Chapters
Table of Contents
