Cleaning Reminder - Electrolux EOC5640 User Manual

22 www.electrolux.com
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as the
Pyrolysis function. It can
cause damage to the
appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When
set the necessary procedure:
Option
P1
P2
After 2 seconds the procedure starts.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set
temperature, the door locks. The
display shows the symbol
bars of the heat indicator until the
door unlocks.
To stop Pyrolysis before it is
completed, turn the knob for the oven
functions to the off position.
6. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
flashes, press or
Description
If the oven is
not very
dirty. Time of
the proce‐
dure: 1 h 30
min.
If you cannot
easily re‐
move the
dirt. Time of
the proce‐
dure: 2 h 30
min.
and the
7. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.

9.5 Cleaning reminder

To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press
the same time while PYR
flashes in the display.
9.6 Cleaning the oven door
to
The oven door has four glass panels.
You can remove the oven door and the
internal glass panels to clean them.
The oven door can close if
you try to remove the glass
panels before you remove
the oven door.
CAUTION!
Do not use the appliance
without the glass panels.
1. Fully open the door and identify the
hinge to the right side of the door.
2. Push the tightening component until
it pulls back.
3. Hold the pushed component with one
hand. Use a screwdriver with the
and at