Subscribe to Our Youtube Channel
Related Manuals for Pentair VSe
Summary of Contents for Pentair VSe
- Page 1 VSe VARIABLE SPEED PUMPS INSTALLATION AND USER’S GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS 251PD340 Rev.Nov 2023...
- Page 2 FAILURE TO FOLLOW ALL INSTRUCTIONS personal injury, or major property damage if ignored. to Pentair. Unless otherwise stated, the names and brands of third parties used in the present document are not used to indicate any AND WARNINGS CAN RESULT IN SERIOUS Warns about hazards that may cause death, serious affiliation or endorsement between the owners of these trade names and Pentair.
- Page 3 Before servicing equipment, make note of the filter pressure. Be sure that Pentair variable speed pumps equipped with VSe drive can be programmed to run at speeds over set periods pool (particularly a child wading pool) or spa outlet and suction is all controls are set to ensure the system cannot inadvertently start during of time.
- Page 4 2.1. DISPLAY Wiring 1. Ensure all appropriate electrical breakers and switches are turned off before wiring the motor. 1. STATUS LED – When active (green), indicates that the pump is in ACTIVE status, either running a program or in stand-by STORED CHARGE - Wait at least sixty (60) seconds before servicing.
- Page 5 3.2. PLUMBING AND FITTINGS Do NOT run the pump dry, the shaft seal will be damaged and the pump will start leaking. If this occurs, the damaged seal must be replaced. ALWAYS maintain proper water level in your pool (half way up •...
- Page 6 4.4. OPERATING THE PUMP WHILE RUNNING 5.1. SETTING THE CLOCK When power is first connected to the pump after production, the clock will blink to indicate that is has not been • Pressing the SET button will cycle through the current parameters: set.
- Page 7 All VSe mounted pumps can be controlled via external input signal. VSe drive can be operated in 7 languages: EN, IT, FR, NL, DE, ES, PT. Use a 0.25 mm2 four-conductor cable to connect an automation system to the pump.
- Page 8 7. PUMP MAINTENANCE The VSe board provides a +3.3V Output Signal that can be used to trigger its own Digital Inputs. This output signal is the recommended input for Speed Digital Inputs. The output signal will need to be switched via an Ex- Always disconnect power to the pump at the circuit breaker and relieve pressure in the filtration system before servicing the pump.
- Page 9 8. Drive Removal and Installation TO PREVENT FREEZE DAMAGE: 1. Press ON/STOP to stop the pump and disconnect all power to the To avoid dangerous or fatal electrical shock hazard, switch OFF power to motor before working on pump pump at the circuit breaker. or motor.
- Page 10 Ave. de Sévelin 20, CH-1004 - LAUSANNE, Svizzera Underneath and will need to be replaced after prolonged operation. Tutti i marchi e i loghi Pentair indicati sono di proprietà di Pentair. Marchi e loghi di terze parti, registrati e non, sono di proprietà dei Motor rispettivi titolari.
Need help?
Do you have a question about the VSe and is the answer not in the manual?
Questions and answers