User manual Quick Installation Guide INTRODUCTION GENERAL PRODUCT SPECIFICATIONS The Vicair Active O2 is a wheelchair seat cushion that provides a high level of skin protection for Product name: Vicair Active O2 active wheelchair users with a high risk of Manufactured by: Vicair B.V., The...
Page 3
Caution! Do not place the topside of the Vicair Warning! Make sure that your tailbone and O2 cushion against the glass of the washer door.
Page 4
Checking for “bottoming out”: Ready for use Image 6 - Quick Installation Guide This Vicair product is ready for use. It has its own Warning! Your tailbone and pelvic bones should unique filling grade, depending on size and not touch the bottom of the cushion. Checking model.
Minimum: 0%, maximum 100% Daily fluff-up Warning! Every three months, check the product Vicair B.V. recommends to fluff-up the four rear for wear and deflated cells. In case of serious compartments of your Vicair Active O2 cushion damage, or a large number of deflated cells, do before use on a daily basis.
Page 6
Do not tumble dry instructions underneath. The instructions your Vicair Active O2 cushion but let it air dry correspond to image i (I, II & III) on the Quick (5-6 hours).
Page 7
Open the SmartCell liner’s zipper and add or occur within the above mentioned warranty remove the desired number of SmartCells. period, Vicair B.V. will – at its own choice – repair • Close the zipper. Make sure that you do not or replace the product free of charge.
Page 8
Height Vicair Active O2 6 = 6 cm / 2,5 inch Height Vicair Active O2 9 = 9 cm / 3,5 inch Available sizes: WIDTH inch Only available in height 9 cm / 3,5 inch. Height Information about availability of other sizes on request.
Need help?
Do you have a question about the Active O2 and is the answer not in the manual?
Questions and answers