Table Of Contents; J2 Plus Back And Accessories; Side Plate Installation - Sunrise Medical Quickie GTi Titanium None User Instruction Manual & Warranty

2
J2 PLUS BACK AND ACCESSORIES............................................................. 2
INSTALLATION INSTRUCTIONS ................................................................. 3
Side Plate Installation ...................................................................... 3
Back Shell Installation ...................................................................... 5
Seat to Back Angle Adjustment .......................................................... 7
Vanity Flap Adjustment ..................................................................... 7
Growth Plate Adjustment................................................................... 8
Lateral Bracket Installtion ................................................................. 8
Lateral Bracket Vertical Adjustment..................................................... 8
REMOVAL AND REPLACEMENT .................................................................. 9
EASY MAINTENANCE AND CLEANING ........................................................ 10
WARRANTY ............................................................................................ 11
The J2 Plus Back is designed to supply the clinician with the means to provide the
client with a back support that can accommodate a heavier load capacity and provide
all the benefits of a solid back support.
Maximum User weight 650lbs (293Kg).
CAUTION- Installing a back support on a wheelchair may affect the center of gravity of the wheel-
chair and may cause the wheelchair to tip backwards potentially resulting in injury.
CAUTION-1) Maximum occupant weight for the J2 plus back is 650 lbs, the user should check
weight restrictions of the chair on which the back will be placed.
2) The J2 Plus back can be used up to 60 degrees tilt in space for stationary applications.
3) While using a J2 Plus back on a tilt in space chair, the chair should be returned to
is upright position when the occupant is being propelled.
Always assess the need for anti-tippers and amputee axle adapter brackets to be added
to the wheelchair to help increase stability.

J2 PLUS BACK AND ACCESSORIES

XT200005 Rev. B
T a b l e o f C o n t e n t s I n s t a l l a t i o n
INSTALLING THE J2 PLUS BACK
The J2 Plus Back is designed to replace the wheel-
chair's sling upholstery. The initial installation should
be done as follows:

SIDE PLATE INSTALLATION

NOTE- Ensure the side plates are correct for 8° or straight
back canes.
Tools: 3/16 Allen wrench
NOTE- It is recommended that the push handles (E) be
installed in the tallest setting.
1. Remove the lower clamp assembly (A) from the
left and right side plate (D), set aside with
attaching hardware (B).
2. Attach the left side plate (D) to the push handle
by loosening the upper clamp fastener to allow
clamp (C) to slide over push handle, loosely
secure clamp to push handle. Adjust side plate to
the correct height, loosen and tighten clamp as
required. Repeat process for the right side.
3. Install lower clamps by equally tightening the
provided fasteners so that the gap between side
plate and the lower clamp is equal from front to
back. See figure.
3
E
D
C
B
A
Figure 1
Equal gap
Equal gap
Figure 2 View from above
XT200005 Rev. B