Table of Contents
Advertisement
Q u i c k
R e f e r e n c e
If multiple slots are to be HotSync'd simultaneously, each must
communicate with a different host PC. If the application requires
simultaneous connection to a single host database, additional
software, available from Symbol, is required.
Terminals inserted into daisy-chained cradles are HotSync'd in a
round-robin fashion simultaneously with any HotSyncs from local
slots. Daisy-chained cradles share a logical "fifth slot" on the
CRD2700-4200E, which, while it shares equal priority with the
local slots, allows only one HotSync at a time.
Performing HotSync
Insert the SPT 1700/SPT1800
terminal into a local cradle slot, or
a slot on an interconnected serial
cradle to initiate communication
between the terminal and the host.
The cradle slot's LED turns red,
then flashes green, indicating that
the host and terminal are
communicating (when the terminal
has been properly inserted). Do not remove the terminal from the
cradle while the LED is flashing green, this disrupts
communication and data may be lost. If the terminal is inserted
into an interconnected serial cradle slot while another terminal on
the serial cradle chain is communicating with a host, the terminal
waits (its LED remains red) until the first terminal finishes
communicating, then the slot's LED turns green until the terminal
is removed from the slot. To remove the terminal, pull it straight up
from the cradle slot.
19
Advertisement
Table of Contents
