Table of Contents
Advertisement
Q u i c k
For the 1 DHCP Address NAPT Mode:
Set NAPT Mode to 1 (see set NAPT Mode, page 12).
When NAPT Mode is set to 1, the cradle uses 5 private
NAPT addresses (192.168.1.1 through 192.168.1.5 by
default; the network will not see these addresses).
d. Press Q to return to the main Cradle Utilities menu.
e. Press F to write these values to Flash memory and reset
the cradle.
Static Mode
If there is no DHCP server on the network, the cradle must be
manually configured with IP addresses and other network-related
information.
Cradle Configuration, Static Mode:
1. Start a cradle Terminal Emulation session:
a. Connect the modular end of the cable (p/n 170013-000)
and a null modem adapter between the expansion port of
the cradle and a COM port on a host computer.
b. Start a terminal emulation session on the host computer.
Use standard terminal emulator software, such as Pro-
Comm
settings: 115200 bps, 8N1, XON/XOFF flow control,
ASCII file transfer protocol.
c. Power up the cradle. Before the power-up LED sequence
begins, press "a" from the terminal program to load the
R e f e r e n c e
or Hyperterminal
TM
. Use terminal emulation
TM
13
Advertisement
Table of Contents
