Sales And Service; Shipping And Inspection; Unpacking For Novawheel™ Nwb-Dc & Dc+ Dry/Convey Models; Unpacking - NovaTec NovaWheel NWB- DC+ Series User Manual

1.0 SALES AND SERVICE

NOVATEC maintains qualified sales, engineering, and
service personnel to assist in any way possible. If you
have any comments concerning the types of equipment
which NOVATEC manufactures that might improve your
process, or any questions concerning service, we urge
you to contact us. Please have you Model and Serial
Number handy.
Sales: 1-800-BEST-DRY ●1-800-237-8379
Fax: 410-789-4638 ● Sales@novatec.com
Technical Service Department: 1-800-938-6682
Service@novatec.com

2.0 SHIPPING AND INSPECTION

Although NOVATEC uses reputed carriers to deliver
products, it has no control over the products once it
leaves the manufacturing facility. Upon receiving the
products, thoroughly inspect all equipment inside and out
for damage that may have occurred during shipment. If
any damage is found, a claim should be filed immediately
with your carrier.
NOVATEC thoroughly tests and inspects all products
before shipment. You are to make the piping, and electri-
cal connections for final installation and commissioning.
If there any problems, shut down the equipment and
contact the NOVATEC Technical Service Department.
3.0 UNPACKING for NovaWheel™ NWB-DC &
DC+ DRY/CONVEY MODELS

3.1 Unpacking

3.1.1 Tools You Will Need for Unpacking:

• Box Cutter
• Mallet or hammer
• Tin Snips
• ½" socket wrench for -150 through -300 model only

3.1.2 Unpacking Instructions:

1–Please look for any signs of damage and report to
your carrier immediately.
2–Unpack the Dryer/Hopper
3–Remove shrink wrap, and any wood framing
attached to the skid.
4–Cut the metal strapping that secures the Dryer/
Hopper to the skid.
5–Lift the Dryer/Hopper off the pallet and set it in a
low-traffic area.
NOTE: All models are shipped with casters installed ex-
cept the -150 & -200, so while they are being supported
by the fork lift, attach one of the supplied casters under
each corner of the frame using a ½" socket wrench.
–Unpack the components to be assembled from separate
cartons.
–Remove the shrink wrap from the carton(s) and take out
the contents.
NOTE: The Hopper Receiver should be set on the floor
with the bottom inside the round fiber tube (supplied) so
the bottom flapper is protected by the tube.

3.1.3 List of UNPACKED CONTENTS:

• Dryer/Hopper Assembly
• Machine Mount Receiver (with sight glass)
• Hopper Receiver on Fiber Tube (with flapper valve
underneath)
• 5' Long Pickup Wand
• Photo Eye Level Sensor
• 50' of 1.5"of Flex Hose*
• 8 Hose Clamps
• Casters, Bolts & Washers (packed separately for
-150 & -200
6