Programming/Deleting The Handheld Or Wall Transmitter - GEIGER SOLIDline Original Assembly And Operating Instructions

9. Programming/deleting the handheld or wall transmitter

In Smart Home mode, the handheld or wall transmitters can be directly programmed on the
Loxone Miniserver. For more information please refer to the assembly and operation instructions
of the transmitters or click: www.loxone.com/help/lcair
Activate the learning mode
Connect the motor with the electrical power supply.
Switch on mains.
The motor makes two short movements (2 x „click").
The learning mode is now available for the next 30 minutes.
Press the RIGHT and LEFT keys of the transmitter
simultaneously for about 10 seconds until the channel LED
flashes. The transmitter is now in the learning mode.
Press the STOP key for about 1,5 seconds. The motor
which is nearest to the transmitter or which has the best
reception confirms the learning mode (2 x „click").
I
Should the improper motor be selected,
move closer to the motor you need.
Learning the handheld or wall transmitter
I
The learning mode must be activated and the motor must be selected
first in order to learn/delete the transmitter.
Select on the transmitter the channel on which the motor
should be operated.
Press STOP and UP keys for approximately 1,5 seconds.
The motor confirms (1 x „click").The selected channel is
programmed in the motor.
In order to learn further channels: Select channel on the
transmitter and press STOP and UP keys for 1.5 seconds.
Up to 5 different channels can be learned.
Deactivate the learning mode
To deactivate the learning mode, press the LEFT and RIGHT
keys simultaneously for about 4 seconds until the channel
LED stops blinking. The learning mode is deactivated.
Delete the learned handheld or wall transmitter
I
The learning mode must be activated and the motor must be selected
first in order to learn/delete the transmitter.
Select on the transmitter the channel which should be
deleted.
Press STOP and DOWN keys for approximately
1,5 seconds.
The motor confirms (4x „click").The selected channel is
deleted in the motor.
Deactivate the learning mode
To deactivate the learning mode, press the LEFT and RIGHT
keys simultaneously for about 4 seconds until the channel
LED stops blinking. The learning mode is deactivated.
www.geiger.de
connect to
mains
2 x click
ON
OFF
1 2 3 4 5 6
and
approx. 10 sec.
AIR
2 x click
1 2 3 4 5 6
for
approx. 1,5 sec.
AIR
1 x click
1 2 3 4 5 6
and
approx. 1,5 sec.
AIR
1 2 3 4 5 6
and
approx. 4 sec.
AIR
4 x click
1 2 3 4 5 6
and
approx. 1,5 sec.
AIR
1 2 3 4 5 6
and
approx. 4 sec.
AIR
EN
7
EN