Siemens SIMATIC S7-1500 Manual page 19

Parameter
Channel parameters in operating mode PM-switching:
Channel n
Diagnostics: Wire break
Channel activated
Channel failure acknowledge
Max. readback time dark test
Disable dark test for 48 hours
Max. readback time switch on
test
Activated light test
Channel parameters in operating
mode PP-switching:
Channel n
Diagnostics: Wire break
Channel activated
Channel failure acknowledge
Max. readback time dark test
Disable dark test for 48 hours
Max. readback time switch on
test
Activated light test
Digital output module F-DQ 8x24VDC/2A PPM (6ES7526-2BF00-0AB0)
Manual, 01/2016, A5E03858037-AA
Value range
Disable
•
Enable
•
Disable
•
Enable
•
Manual
•
Automatic
•
The value range offered depends on the
F-CPU in use and on the configuration of the
F-parameter "Reintegration after channel fault".
0.8 to 400.0 ms
Disable
•
Enable
•
0.8 to 5.0 ms
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Manual
•
Automatic
•
The value range offered depends on the F-
CPU in use and on the configuration of the F-
parameter "Reintegration after channel fault".
0.8 to 400.0 ms
Disable
0.8 to 5.0 ms
Enable
Parameters/address space
4.1 Parameters
Parameter reas-
signment in RUN
No Channel
No Channel
No Channel
No Channel
No Channel
No Channel
No Channel
No Channel
No Channel 1...7
(Channel 0
always enabled)
No Channel
No Module
(Channel 0)
No Module
No Module
(Channel 0)
No Module
Scope
19