Cisco CGR 2010 Installing And Connecting page 23

Installing and Connecting the Router
Auxiliary Port, Console Port, and Adapter Pinouts for the Cisco CGR 2010 Router
Figure 16 Identifying a Rollover Cable
Pin 1
Table 6 on page 47
Table 6 RJ-45 Rolled Console Cable Pinouts
Signal Pin
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
Console Port Connection to a PC
To connect a PC terminal to the console port, use the RJ-45-to-RJ-45 rollover cable, and either the RJ-45-to-DB-25
female DTE adapter or the RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL).
The default parameters for the console port are:

9600 baud

8 data bits

No parity generated or checked

1 stop bit

No Flow Control
Console Port Signaling and Cabling with a DB-9 Adapter
This section describes the console port signaling and cabling with a DB-9 adapter. See
Figure 18 on page 48).
Pin 1 on one connector and
pin 8 on the other connector
should be the same color.
shows the RJ-45 rolled (console) cable pinouts:
Pin Signal
8 -
7 -
6 -
5 -
4 -
3 -
2 -
1 -
Pin 8
47
Figure 17 on page 48 and