Siemens SIWAREX WL270 CP-S SB Operating Instructions Manual page 26

Installation
5.2 Mounting the pressure piece set
Compressive strength of the mounting surfaces
The compressive strength of the mounting surfaces has to be appropriate for the surface
pressure of the pressure pieces.
Align the load cell
The lower pressure piece features a pin. This prevents the load cell from twisting. You can
align the lower pressure piece accordingly to determine the orientation of the cable terminal
on the load cell.
Installing the load cell
CAUTION
Personal injuries, damage to the load cells
Insufficiently secured loads can fall and cause injuries or material damage. Therefore,
appropriate lifting tools must be used to lift the load bearing implement. The corresponding
safety regulations must be observed.
CAUTION
Destruction of the load cells and the pressure piece set
Check that the load cells and installation unit are installed correctly, e.g. by checking the
mounting dimensions and oscillation distances. Incorrect assembly can lead to the
destruction of the load cell and the installation unit.
Ensure that the cable does not become damaged or is cut off.
Lay the cables through cable glands in the form of a vertical downwards loop to discourage
the penetration of water.
Adapt the procedure to the installation conditions.
26
Operating Instructions, 11/2010, A5E03323543B
CP-S SB