Page 1
12, Qu n 4, TP. H Chí Minh Tel: +84 8 39 113 113 - Fax: +84 8 39 113 114 www.hafele.com.vn INSTRUCTION ON MOUNTING AND USE Model Häfele article number HH-TVG90A 539.81.065 Häfele Design Center Häfele Home Showroom Häfele Ha Noi Häfele Da Nang Häfele Nha Trang Office...
Page 7
EN - Instruction on mounting and use Closely follow the instructions set out in this manual. All Cleaning and user maintenance shall not responsibility, for any eventual inconveniences, damages or be made by children without supervision. fires caused by not complying with the instructions in this manual, is declined.
WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. The hood is designed to be used either for exhausting or filter Do not use with a programmer, timer, separate remote control version.
RECOMMENDATION: We recommend you to install the • Perform, in the back of the hob, a rectangular hole with metal box containing the electronic components at a distance the following dimensions: (Fig. 20) of at least 10 cm from the ground and sufficiently from all the Hood 60cm Model: 542x100mm.
Note: If the panel is closed (hood is off) key T3 activates Operation the opening of the suction panel first and then sets the The hood is equipped with a “TOUCH” device to control the hood to the suction speed (power) 1. lights and speed.
Page 11
Remote control Warning! Some functions of this remote control may only be activated with certain hood models. Remote control affiliation: Keep T2 +T5 pressed Description of the remote control functions T1. OFF key Open/Close the panel T2. Remote control affiliation key T3.
The hood has low efficiency Maintenance of the remote control Make sure that: • The motor speed selected is sufficient for the quantity of Cleaning the remote control: fumes present Clean the remote control with a damp cloth and a neutral •...
Page 13
Replacing lamps (Depending on the model available).Disconnect the appliance from the electricity. Warning! Prior to touching the light bulbs ensure they are cooled down. Replace the old light bulb with the one of the same type as specified in the feature label or near the light lamp on the hood.