Intended use ..................5 Operating instructions ..................5 Technical data ....................5 Layout ......................6 Setting up instructions ..................7 Before starting up ....................7 Starting up ....................7-9 Hose drainage ....................9 Recommendations for drying with the Comedes Demecto 20 ......10-11 Maintenance ....................12 Frequently asked questions ................13 ENG-1 www.comedes.com...
Dear customer, Thank you for buying the Demecto 20 from Comedes GmbH. You have purchased a powerful dehumidifier, which has been developed in accordance with the latest technical standards. To ensure that your device offers you faithful service for a long time, please study these operating instructions in detail, especially the safety information.
• Do not use the device in enclosed spaces smaller than 5m². • Do not use the device outside the operating temperature range of 5°C – 32°C. • Always run the device for at least 35 minutes (risk of damage to the compressor). The fact that the device ENG-3 www.comedes.com...
Page 5
• Plug the power cord firmly and securely into the socket. • Operate the unit only to a grounded socket. • Do not operate the dehumidifier on a power strip or extenion cable. • If the device switches off, also wait at least 10 minutes before restart. ENG-4 www.comedes.com...
If the humidity level increases again, the device switches on again automatically. The device switches off automatically when the water tank is full. Technical data Product name: Comedes Demecto 20 Voltage: 220~240V 50 Hz Power rating: 4800W...
The higher the humidity in a room and the higher the temperature in that room, the more effectively the Comedes Demecto 20 can dehumidify the air. The compressor therefore generates heat and warms up the air in the room. This is perfectly normal and is no cause for alarm.
Page 9
The device is equipped with a modern hygrostat (humidistat) and turns off automatically after the desired humidity is reached, to save power.If the humidity increase in the room again, the Comedes Demecto 20 will automatically restart. Repeatedly pressing the humidity setting button, a target humidity of CO, 30%, 35%, 40%, 45%, 50%, 55%, 60%, 65%, 70%, 75%, 80%, 85%, 90% and AU could be set.
Emptying water tank: If the water tank is full, the Comedes Demecto 20 switches off automatically and the red LED (tank “full” indicator, Fig. 3) will light up. You need to empty the water tank before you can continue using the Demecto 20.
Recommendations for drying with the Comedes Demecto 20 To achieve the best possible dehumidifying results with the Demecto 20 while using as little energy as possible, we offer the following tips: Since this manual can only offer a limited amount of advice, we would recommend that you consult the more detailed information available at: www.luftentfeuchter-tipps.de...
Page 12
Once this has been done the rooms can be dried using condensation driers such as the Demecto 20. In this case the dehumidifier is run in continuous operation mode. The ambient temperature needs to be at least 20°C (but not above 27°C). Additional heating can be provided by an electric heater if necessary.
Maintenance The Comedes Demecto 20 is largely maintenance-free. To maintain the level of dehumidifying efficiency you need to clean the filter at least once a month, or more often if necessary. To do this, switch off the device, pull the power cable and remove the water tank at the back of the device.
3. Is the red lamp on? 4. Is the fuse burned out? 5. If the above points are ok, try again in 10 minutes. 6. If the device is still not working, please contact service@comedes.com Inadequate dehumidifying results. 1. Is the dust filter soiled? 2.
Need help?
Do you have a question about the Demecto 20 and is the answer not in the manual?
Questions and answers