FUTABA T18MZ Software Update Changes page 3

1M23N26419
This software updates or alters the functions and features noted below. The instructions and information that follow are meant as a supplement to the original instruction
manual that accompanied the T18MZ transmitter. Please refer to the original instruction manual where applicable, but replace the steps indicated below with these
instructions. Please note that the software update will be finalized the first time that the T18MZ is powered up, after the software has been applied. As such, it may require a
few moments before the Start screen appears. Please check to ensure that the update has been installed.
1) Select the System Menu.
2) Touch the [Information] button.
3) Confirm that the information in the display indicates the Editor and Encoder version numbers as noted above.
1. SBS-01RB Brushless motor RPM sensor function
The T18MZ has been made compatible with the SBS-01RB brushless
motor RPM sensor.
■ "Type" → "Brushless Motor"
■ "Pole" → Each aircraft using a brushless motor has a different number of
poles. The number of poles of the motor used must be checked against
the motor instruction manual and entered at the "Pole".
2. SBS-01S S.BUS2 servo sensor function
The T18MZ has been made compatible with the SBS-01S S.BUS2 servo
sensor.
Telemetry data / Min Max data
When 1/4 is pushed, it's to the next page.
page
1/4
◆ Current 1 ⇒ Current alert setting of servo 1
◆ Temperature 1 ⇒ Temperature alert setting of servo 1
page
2/4
◆ Angle 1 ⇒ Angle alert setting of servo 1
◆ Connection Alarm 1 ⇒ Connection alert setting of servo 1
page
3/4
◆ Current 2 ⇒ Current alert setting of servo 2
◆ Temperature 2 ⇒ Temperature alert setting of servo 2
page
4/4
◆ Angle 2 ⇒ Angle alert setting of servo 2
◆ Connection Alarm 2 ⇒ Connection alert setting of servo 2
【Setting method】
① At the linkage menu Telemetry screen, select "Servo Adaptor".
② Activate the alert function by touching the [Alert] [INH] button.
[INH] ⇒ [ON/OFF].
T18MZ SOFTWARE UPDATE CHANGES
(Editor Version: 2.5 Encoder version: 2.2)
Min Max data is reset.
Indicates that the alarm will start when
the current rises above the set value.
Indicates that the alarm will start when
the current falls below the set value.
③ The numerical value is input to "Threshold".
④ Press to setup vibration alerts. 4 types of
vibration selections are possible.
⑤ Press to setup "speech". A voice alarm is given in
addition to the alarm sound when the alarm was
activated.
⑥ Activate the servo connection alert function by touching the [Connection
Alarm] [INH] button.
[INH] ⇒ [ON/OFF].
This screen appears and an alarm sounds to indicate a servo connection error.
3. It corresponded to the following sensor.
Refer to the sensor instruction manual for more information.
4. Dual receiver function (Addition of instructions)
A telemetry function cannot be used for the 2nd receiver. The voltage and
Ext voltage of a 2nd receiver cannot be monitored with a transmitter.
5. Area Code is EUROPE only FASST and S-FHSS
applied to EN300 328 V.1.8.1
FASST MULTI CH mode, 7CH mode and S-FHSS apply to EN300 328
V.1.8.1adaptive system. (V.1.8.1 is the latest version of European regulation
for 2.4GHz radio equipment which can output RF power less than 100mW.)