Advertisement
Available languages
Available languages
EN
24
This symbol on the device or packaging means that this product
cannot be treated as other municipal waste. It must be handed over
to the appropriate collection and recycling centre for electrical and
electronic equipment. The correct disposal and scrapping helps in
the scope of elimination of the negative impact of scrapped devices on the
environment and health. In order to obtain detailed information regarding the
recycling possibilities of this device, please contact your local city hall, city
cleaning services or the store, in which you purchased this product.
Application
This device can be used as a ducted cooker hood (discharge of fumes to the
outside) or as a recirculating cooker hood (fumes are filtered and discharged
back into the room). The models of cooker hoods that are not equipped with
a discharge fan function only as an extractor and must be connected to an
extraction device (not included in the set). Guidelines regarding the connection
are supplied with the external extraction device.
Ducted cooker hoodg
The fumes are removed to the outside with the use of a discharge
pipe, which is mounted to the connection flange. Diameter of the discharge
pipe must be equal to diameter of the connection flange.
Note! The discharge pipe is not supplied in a set with the device and must
be purchased separately. In the horizontal part, the pipe must have a slight
inclination upwards (approx. 10°), in order to facilitate the air flow to the
outside. If the cooker hood is equipped with carbon filters, then they must be
removed. Connect the cooker hood to the ventilation duct using a discharge
pipe with a diameter corresponding to the size of the cooker hood's outlet
(connecting flange). The use of ducts with a smaller cross-section reduces the
suction capabilities and drastically increases noisiness of the cooker hood.
Therefore, the manufacturer is not responsible for this condition.
! Use the shortest possible duct.
! Use a duct with the lowest number of bends (maximum bending angle: 90°).
! Avoid radical changes in the duct's cross-section.
! Use a duct with the smoothest inner surface.
! The duct material must be compliant with the applicable standards.
KCH 4860 B / KCH 4890 B
Advertisement
