Weil-McLain 2 Series Manual page 68

®
SlimFit Series 2
CONTRACTOR menus
cal settings.
severe personal injury, death or substantial property
damage.
SlimFit control menu access — accessing contractor menus
Screens shown above are typical
only. Actual screens depend on
control settings chosen.
68
COMMERCIAL CONDENSING GAS
Failure to set correctly could result in
USER MODE
BOILER
SETTINGS
PRIORITY 1
PRIORITY 2
PRIORITY 3
ASSIGN INPUTS
DIAGNOSTICS
MAINTENANCE
INFO
SET TIME &
DATE
- — Boiler Manual
FIRED WATER BOILER
1. Access contractor menus by pressing and holding the UP and
-
DOWN arrow keys at the same time for 7 seconds.
2. See the following pages for explanations of control setting options.
The default for this setting is
in this manual assume the USER MODE is set to BASIC. For
advanced features available in ADVANCED mode, see the
SlimFit
Advanced Manual.
Set/change boiler model, control type,
high altitude setting, ODT sensor require-
ment, manual reset, high limit and WWSD
temperature settings, outdoor sensor temp
adjustment, circulator exercising, freeze
protection setup, and restore to factory
default option.
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 1."
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 2."
These settings control operating tempera-
tures and behaviors for systems that are
assigned to "PRIORITY 3."
These settings assign Priority 1, 2 or 3 to
each of the three inputs to the control.
Use to review current and historical infor-
mation including previous lockouts.
Used to set contractor contact information,
boiler information and maintenance dates.
Use to set date and time — important since
fault occurrences are date/time stamped.
mode. Screens shown
See page 69
See page 70
See page 70
See page 70
See page 71
See page 73
See page 78
None
Part number 550-100-180/0917