Replacing The System Processor Assembly - IBM 8408-E8D Manual

8. Continue with "Replacing the system processor assembly."

Replacing the system processor assembly

Replace the system processor assembly after you have installed the system onto the rails.
CAUTION:
The system processor assembly requires two people to install into the system.
1. Slide both the rails out of the enclosure (A) until the slide release buttons (one on each side) lock into
place.
Figure 15. Sliding out the system processor assembly rails
2. Install the system processor assembly:
a. With the rails extended and locked in position, and two people (one person on each side of the
system processor assembly), lift the system processor assembly by using both handles on each
side.
b. Position the system outside of the slide rails so that with the three pins on either side of the
processor assembly are slightly above the rails.
c. Carefully move the system horizontally toward the rack, until the three pins on each side are over
their respective slots on the rails.
d. With the system processor assembly secured on the rails, lift the slide release buttons (one on each
side) to unlock the rails (B).
e. By using the lower handles, slide the system processor assembly completely into the enclosure.
14
Power Systems: Installing the IBM Power 750 (8408-E8D) and IBM PowerLinux 7R4 (8248-L4T)