Figure 3. Rear of rack rail alignment and nut clip locations
9. Secure both rails to the rear EIA support flanges using four M5 x 16mm screws (C).
Removing the power supply shipping bracket and the shipping covers
If you haven't already done so, remove the front and rear shipping covers and the rear shipping bracket
before you remove the processor assembly and install the system chassis.
1. Remove the screws that attach the front shipping cover (A) to the system chassis, and remove the
front shipping cover.
2. At the rear of the system, remove the power supply retaining bracket (B) and then remove the rear
shipping cover (C) from the chassis.
Installing the server into a rack
5