Adjustments; General; Parking Brake - Jacobsen Turfcaet Series Manual

Table of Contents

Advertisement

Available languages

Available languages

4

ADJUSTMENTS

4.1

GENERAL ________________________________________________________________

!
WARNING
To prevent injury, lower implements to the ground,
disengage all drives, engage parking brake, stop
engine, and remove key from ignition switch before
making any adjustments or performing maintenance.
Make sure the mower is parked on a solid and level
surface. Never work on a mower that is supported
only by the jack. Always use jack stands.
If only the front or rear of the mower is raised, place
chocks in front of and behind the wheels that are not
raised.
1.
Adjustments and maintenance should always be
performed
by
a
4.2

PARKING BRAKE__________________________________________________________

If optional turn assist brakes are installed, slide the lock
pin toward the rear and to the left to lock the pedals
together.
NOTE: The brakes installed on the mower are self
adjusting and should not require adjustment under
normal operating conditions. If linings or brake drums
appear
worn
or
damaged,
immediately by an experienced service technician.
1. For maximum braking power, a force of 135 lbs. (61
kg) is required to engage the parking brake.
2. Adjust brake rods on the right and left hand sides so
they both begin brake engagement at the same
time. If adjustment is needed, loosen the lock nut
(A), remove the hairpin and clevis pin (B).
3. Rotate clevis (C) as required.
4. Tighten locknut (A). Assemble clevis pin (B) and
hairpin.
5. Additional adjustment is available at the brake arm if
necessary by tightening nut (D). Front wheels must
be removed before making adjustments at brake
arm.
qualified
technician.
If
have
them
replaced
adjustment cannot be made, contact an authorized
Jacobsen Dealer.
2. Replace,
components.
3. Long hair, jewelry, or loose fitting clothing may get
tangled in moving parts.
Be careful to prevent entrapment of the hands and
fingers between moving and fixed components of the
machine.
4. Do not change governor settings or overspeed the
engine.
proper
B
C
ADJUSTMENTS
do
not
adjust,
worn
!
CAUTION
A
4
or
damaged
Figure 4A
D
Figure 4B
en-15

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Turfcat t628d

Table of Contents