Rear Panel; Programmability; Storing Patches; Recalling Patches - Blackstar SILVERLINE Series Owner's Manual

Rear Panel

28. Mains Input
The supplied detachable mains lead is connected here. The lead should only
be connected to a power outlet that is compatible with the voltage, power and
frequency requirements stated on the rear panel. If in doubt, seek advice from a
qualified technician.

Programmability

Storing Patches

To store the current sound as a patch:
1. Press and hold any of the four Channel switches for one second. All four
Channel LEDs will begin to flash.
2. Press the Bank switch to toggle through the three banks (green, orange, red)
to choose the store location.
3. Press any of the four Channel switches once to store the patch in the chosen
location.
The LED corresponding to the chosen store location will illuminate and the new
patch will be active.
Green bank = Patches 1-4
Orange bank = Patches 5-8
Red bank = Patches 9-12
The amplifier controls can be used to edit the patch at any stage of the store
process.
Press the Manual switch at any stage to cancel the store process and return the
amplifier to the last state.
Storing a patch will overwrite any previous patch in that location.
Patches can also be stored via Blackstar's INSIDER software or a connected
Blackstar FS-10 footcontroller.

Recalling Patches

Press any Channel switch to load that patch.
Pressing the Bank switch will cycle through the three banks – green-orange-red.
The Channel will be preserved, therefore the corresponding patch within the current
Bank will be loaded when scrolling through the Banks.
Alternatively, patches can be recalled via Blackstar's INSIDER software or any
connected footcontroller.
16
Factory Patches Table
Green Bank - Live Rig 1
Channel Patch Name Voice Response
CH1 LR1 - Clean Clean Warm 6L6
CH2 LR1 - Crunch Crunch EL34
CH3 LR1- Rhythm Super Crunch EL34
CH4 LR1 - Lead OD 1 KT88
Orange Bank - Live Rig 2
Channel Patch Name Voice Response
CH1 LR2 - Clean Clean Warm 6V6
CH2 LR2 - Crunch Clean Bright KT66
CH3 LR2- Rhythm OD 1 EL84
CH4 LR2 - Lead Super Crunch 6L6
Red Bank - Live Rig 3
Channel Patch Name Voice Response
CH1 LR3 - Clean Clean Bright KT88
CH2 LR3 - Crunch Crunch EL84
CH3 LR3- Rhythm Super Crunch 6V6
CH4 LR3 - Lead OD 2 KT88
Effect(s) Description
Spring Reverb US clean with high
headroom, perfect as a
platform for your pedals
Hall Reverb British low gain crunch with
natural reverb
Tape Delay, Hall British classic rock crunch,
Reverb ideal for guitars with
humbuckers
Analogue Delay Full sounding dynamic lead
Effect(s) Description
Plate Reverb US low wattage 'sag' clean
tone with natural reverb
Hall Reverb Rhythm tone with breakup,
great for a classic Indie
sound
Hall Reverb Smooth drive with a slight
mid boost
Analogue Delay, Balanced lead tone with
Hall Reverb delay, perfect for solos
Effect(s) Description
Flanger, Modulated clean tone,
Analogue Delay, ideal for appegiated
Hall Reverb chords
Plate Reverb Dynamic crunch, perfect
for big open chords
Analogue Delay, Compressed crunch, great
Plate Reverb for rhythm playing
Analogue Delay, Smooth high gain tone,
Hall Reverb ideal for legato whilst
maintaining note definition
17